MicroVAX II 630QB Technical Manual

Chapter 1 BA123-A Enclosure
- 1.1 Introduction
- 1.2 Enclosure Frame
- 1.3 Control Panel
  - 1.3.1 Mass Storage Shelves
  - 1.3.2 CPU Console Board
- 1.4 Signal Distribution Board
- 1.5 Backplane
- 1.6 Power Supply
- 1.7 I/O Distribution Panel
Chapter 2 Base System
- 2.1 Introduction
- 2.2 KA630-A CPU
  - 2.2.1 Console Program
  - 2.2.2 Primary Bootstrap Program (VMB)
  - 2.2.3 CPU Patch Panel Insert
- 2.3 MS630 Memory Module
Chapter 3 System Options
- 3.1 Introduction
  - 3.1.1 Ordering Options
  - 3.1.2 Module Configuration
- 3.2 Communications
  - 3.2.1 DEQNA Ethernet Interface
  - 3.2.2 DHV11 Asynchronous Multiplexer (Eight Lines)
  - 3.2.3 DHV11 Remote Distribution Cabinet Kit (CK-DHV11-VA)
  - 3.2.4 DLVJ1 Asynchronous Interface (Four Lines)
  - 3.2.5 DMV11 Synchronous Controller
  - 3.2.6 DPV11 Synchronous Interface
  - 3.2.7 DRV11-J High Density Parallel Interface (Four Lines)
  - 3.2.8 DZQ11 Asynchronous Multiplexer (Four Lines)
  - 3.2.9 DZV11 Asynchronous Multiplexer (Eight Lines)
  - 3.2.10 LPV11 Interface Module (For LP25 System Printer)
- 3.3 Disk Storage
  - 3.3.1 RQDX2, RQDX3 Disk Controllers
  - 3.3.2 RD52, RD53 Disk Drives
    - 3.3.2.1 Factory Configuration
    - 3.3.2.2 Disk Formatting
  - 3.3.3 RX50 Diskette Drive
- 3.4 Tape Storage
  - 3.4.1 TK50 Tape Drive Subsystem
Chapter 4 Configuration
- 4.1 Configuration Rules
  - 4.1.1 Module Physical Priority
  - 4.1.2 Expansion Space
    - 4.1.2.1 Backplane
    - 4.1.2.2 I/O Distribution Panel Insert Space
  - 4.1.3 Power Requirement
  - 4.1.4 Bus Loads
  - 4.1.5 Module CSR Addresses and Interrupt Vectors
- 4.2 Configuration Examples
Chapter 5 Diagnostics
- 5.1 Introduction
- 5.2 KA630-A Boot and Diagnostic ROM
  - 5.2.1 Power-up Mode
  - 5.2.2 Console Mode
  - 5.2.3 Console Terminal Error Messages
- 5.3 Power-Up LEDs On Mass Storage, Backup, and Communications Devices
- 5.4 MicroVAX Maintenance System
  - 5.4.1 Test the System (Menu Item #1)
  - 5.4.2 Display System Configuration and Devices (Menu Item #2)
  - 5.4.3 Display the Utilities Menu (Menu Item #3)
  - 5.4.4 Display the Service Menu (Menu Item #4)
  - 5.4.5 Exit the MicroVAX Maintenance System (Menu Item #5)
- 5.5 Troubleshooting
  - 5.5.1 Unknown System Level Problems (System Fails to Boot)
  - 5.5.2 Device-Specific Problems
Chapter 6 FRU Removal and Replacement Procedures
- 6.1 Introduction
- 6.2 Removal of the Exterior Panels
  - 6.2.1 Removal of the Right Side Panel
  - 6.2.2 Removal of the Left Side Panel
- 6.3 On/Off Switch Removal
- 6.4 CPU Console Board Removal
- 6.5 13.3 cm (5.25 in) Mass Storage Device Removal
  - 6.5.1 RD52 Read/Write Board Removal
  - 6.5.2 RD53 Read/Write Board Removal
- 6.6 Fan Removal
  - 6.6.1 Mass Storage Fan Removal
  - 6.6.2 Card-Cage Fan Removal
- 6.7 Module Removal
- 6.8 Door Interlock Switch Removal
- 6.9 Temperature Sensor Removal
- 6.10 Power Supply Removal
- 6.11 Backplane Removal
- 6.12 Filter Connector Removal
Appendix A Console Commands
Appendix B Console Error Messages and Explanations

Company:	Digital Equipment Corporation
Part:	AZ-GLBAA-MN
Date:	1985-11
Keywords:

Address:	http://wwcm.synology.me/pdf/AZ-GLBAA-MN MicroVAX II 630QB Technical Manual.pdf
Site:	Wilber Williams' Computer Museum
Format:	PDF
Size:	13121717 bytes (12.5 MiB)

Address:	http://bitsavers.org/pdf/dec/vax/630/AX-GLBAA-MN_MicroVAX_II_630QB_Technical_Manual_Nov85.pdf
Site:	Al Kossow's Bitsavers
Format:	PDF
Size:	3921033 bytes (3.7 MiB)

Manx – a catalogue of online computer manuals

MicroVAX II 630QB Technical Manual

Copies

Table of Contents